The application rate of ppgi galvanized steel coil is becoming more and more common. In the process of operation, suitable operation methods will be selected. The advantages in the use process are increasing. For better application, let's learn about the installation points of color-coated rolls. Which ones?
Special attention should be paid to the main house used as support during the installation of ppgi galvanized steel coil. The upper part must be on the same plane. According to the needs of the actual situation, the method of tapping or relaxing can be used to adjust its position to meet this requirement. Never direct strikes. Fix the lower part of the bracket, adjust the slope and position of the roof, and correctly configure the color coating board to ensure effective fastening. On the contrary, if the ppgi galvanized steel coil is not properly configured, it will affect the fastening effect of the color-coated plate, especially the part close to the support center point.
In order to avoid the formation of fan-shaped or scattered color coating panels or uneven lower edges of the roof due to improper construction, when installing the color coating panels, check whether the color coating panels are correct at any time, and measure the upper and lower sides of the color coating panels at any time. Whether the distance between the edge of the end and the gutter is equal to avoid tilting of the color coating board. After installation, immediately remove the remaining water debris, rivet rods, fasteners and other metal debris on the roof. These metal debris will cause corrosion of the color coating board.
The above is about the precautions for the installation of ppgi galvanized steel coil. You can choose the appropriate method according to the actual use requirements to avoid unnecessary losses caused by blind operation. If you have other questions, you can pay attention to our website. We will update the website articles regularly. ,I hope to be helpful.
