As the use rate of ppgi Coated Coils becomes more and more common, its quality is also getting higher and higher. Because of its characteristics and advantages, it is widely used by everyone. In order for everyone to have a better application, let’s learn about the installation process of color-coated rolls. Pay attention to what are the points.
Special attention should be paid to the main house used as support during the installation of ppgi Coated Coils. The upper part must be on the same plane. According to the needs of the actual situation, the method of tapping or relaxing can be used to adjust its position to meet this requirement, and it must not be directly attacked. Fix the lower part of the bracket, adjust the slope and position of the roof, and correctly configure the color coating board to ensure effective fastening. On the contrary, if the color-coated plate is not properly configured, it will affect the fastening effect of the color-coated plate, especially the part close to the support center point.
In order to avoid fan-shaped or scattered ppgi Coated Coils or uneven lower edge of the roof due to improper construction, when installing on color coating rolls, check whether the color coating rolls are correct at any time, and measure the edges of the top and bottom ends of the color coating rolls to the sky at any time. Whether the distance of the grooves is equal to avoid tilting of the color coating roll. After installation, immediately remove the remaining water debris, rivet rods, fasteners and other metal debris on the roof. These metal debris will cause corrosion of the color coating board.
The above is about the precautions in the installation process of ppgi Coated Coils. You can understand that the correct operation method can achieve good results during the operation. If you don’t understand, you can call for consultation. We will follow your advice. The actual requirement is to recommend the appropriate one to you to avoid unnecessary trouble in blind operation.
