PPGI steel coils have some advantages such as very good heat insulation, but in the whole process of application, everyone will start the installation first. The whole process of installation is very important to the board’s subsequent work. If it happens in the middle and late stages If it falls, it will endanger the quality of all engineering projects. Today I will tell you how to prevent it from falling.
1. Do a good job in the selection and manipulation of raw materials for the insulation system, and manipulate the quality of the epoxy mortar, color-coated zinc plate and chemical bolts in the software of the engineering building wall insulation system. Adhesives should be scientifically formulated to ensure high polymer content and supporting facilities modifiers, etc., except for the board quality should be qualified.
2. The external wall thermal insulation control system design is effective. The external wall thermal insulation project is a system software engineering project. In the case of the design plan, the matching parts of each structural layer must be considered, for its low compressive strength or poor bonding ability The raw materials need to be designed to strengthen the structure of chemical bolts and improve the adhesion rate.
3. Improve the engineering construction operation of ppgi steel coils. Engineering construction is the weak point of the quality control of the external wall insulation project of the engineering building. Before the construction, the acceptance of the rural basic wall inspection project must be done to ensure the adhesion resistance of the rural grassroots. The compressive strength meets the standard requirements, and the wall flatness is within the controllable range.
Above is the relevant professional knowledge on how to prevent the ppgi steel coils from falling off. The injury caused by the falling problem may be more serious, which not only causes safety hazards to personal safety, but also continues to cause property losses. Therefore, you must carry out structural reinforcement practical operations during the entire installation process to avoid wall panels. Falling leads to risks.
